Press the FEED button to continue printing. Do not touch the print head thermal elements. New Oji Paper Mfg, Co. Run any software program that sends data to the printer. If the auto cutter does not return its normal position by itself, follow the steps below to correct the problem: We shall continue to accept orders during the holiday season although our warehouses will remain closed between 20th December to 7th January for dispatch. Tighten the screws on both sides of the cable connector.

Uploader: Kasar
Date Added: 11 March 2008
File Size: 63.95 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 57872
Price: Free* [*Free Regsitration Required]

Insert the paper roll as shown. To find the character corresponding ellic a hexadecimal number, count across the top of the table for the left digit and count down the left column of the table for the right digit.

CRS | SAM4s Ellix 10 Thermal Printers

Remove the used paper roll core if there is one. Reviews There are no reviews yet. The main features of the printer are as follows: Download Brochure Download Specifications. Turn on the power while holding down the FEED button.


Otherwise, you may damage the power supply or the printer. Otherwise pull it down to scale 1 or 2 as illustrated figure.

Be sure to note the correct direction that the paper comes off the roll. Printing speed may be slower, depending on the data transmission speed and the combination of control commands. Press the FEED button to continue printing.


In this case, clean the printer head as follows: You ellic also hold down the FEED button to feed paper continuously.

Ellix 10 Printer

This equipment has been tested and founded to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules. If the problem is not serious, the auto cutter returns to its normal position without any intervention by the user. Press the FEED button once to advance paper one line. This can be useful in finding software problems. Delivery timeframes depend on the delivery location and might take longer in the case of remote or rural areas.

The printer will lelix all the codes it receives in a two-column format. The Near-End sensor is set to 3 positions at the factory. If the motor knob cannot be rotated, rotate it in the reverse direction to loosen it; then send the DLE ENQ n command. Be careful of the manual cutter. Do not use paper rolls that have the paper glued to the core because the printer cannot detect the paper end correctly.

Ellix | Central Cash Register

The socket-outlet shall be near the equipment and it shall be easily accessible. If the item is out of stock or has been discontinued, we will notify you immediately via phone or email. If this point of sale item is available in stock, it will be dispatched within 48 hours from one of our warehouses in Sydney, Melbourne, Perth, 1 or Brisbane.


Bar code printing is possible by using a bar code command.

E,lix the screws on both sides of the cable connector. To use the hexadecimal dump function, follow these steps: Refer to Table A. For driving the auto cutter of the receipt section, take the interval as a minimum of 10 lines of printing or paper feeding to prevent small pieces of cut paper from dropping into the auto cutter.

Then close the cover. If the auto cutter does not return its normal position by itself, follow the steps below eplix correct the problem: They all connect to the connector panel on the back of the printer, which is shown as below: Setting Up the Printer Do not store thermal paper near a heater or in enclosed places exposed to direct sunlight.